| Snow Performance Water/Methanol Injection Kits |
| |
|
|
| |
|
Stage 1 Boost Cooler $249.00 |
The gasoline Stage 1 Boost Cooler kit is available for forced induction applications that are either fuel injected or carbureted. Operation is very simple: the system starts injecting when the boost switch reaches the user-adjustable point and it injects a fixed amount of fluid through the nozzle until the switch opens again. This makes it a good choice for low to medium boost setups looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, etc. Now with Lifetime Warranty - please see details.
|
Kit includes:
150+ PSI High Volume Pump
2 Quart Reservoir
2 Nozzles To Cover a Wide Range of Horsepower
Required Hardware Needed For Installation
Comprehensive Instructions |
| |
|
|
Stage
2 Boost Cooler $439.00 |
| This kit uses manifold boost pressure to determine when and how much fluid to inject. Proportionally injecting according to boost pressure gives the most accurate delivery of water-methanol and allows the most cooling and performance improvement over the widest range. More power and driveability is the result. It can be used on any forced induction engine: carbureted, fuel injected, turbocharged, positive displacement or centrifugal blowers. The most suitable are the centrifugal supercharged and turbocharged engines, as they build boost is a more progressive manner concerning water-methanol injection. The positive displacement blower engines will work, but it might take more work to dial in the delivery. For higher boost applications (over 25psi), the controller can be upgraded to our VC100 unit. Now with Lifetime Warranty - please see details.
|
Kit includes:
150+ PSI High Volume Pump
2 Quart Reservoir
Digital Variable Controller
2 Nozzles To Cover a Wide Range of Horsepower
All Required Hardware Needed For Installation
Comprehensive Instructions |
| |
|
|
Stage 2 Maf Boost Cooler $439.00
|
| This kit uses the 0 to 5 Volt output signal from the Mass Air Flow sensor on many fuel injected vehicles. This means that any vehicle with a MAF (with a 0-5V output signal) can use this kit, whether they are naturally aspirated or forced induction. If the application is forced induction, it can be used with very fast-spooling turbos, or positive displacement blowers. It is easier to set up with the positive displacement blowers with a MAF signal because it is more progressive in nature vs. the boost pressure signal on those applications. This allows for the most accurate injection possible over the widest range. The result is the most power and driveability possible. Now with Lifetime Warranty - please see details.
|
| Kit includes:
150+ PSI High Volume Pump
2 Quart Reservoir
Digital Variable Controller
2 Nozzles To Cover a Wide Range of Horsepower
All Required Hardware Needed For Installation
Comprehensive Instructions
|
|
|
